Username: Password:

Author Topic: PA systems  (Read 3882 times)

Offline Rev. Ron Cooper

  • Newbie
  • *
  • Posts: 1
    • View Profile
PA systems
« on: February 02, 2003, 03:14:19 AM »
I would like to know if I could hook up a Soundtech PS802 Power Amp (800W) with a Q150 & Q310 graphic equalizers & a Peavey RMS 1662 Mixer w two Soundtech LT5 Trapazoid speakers to an existing system of Peavey R680E Power Mixer w two Peavey 115 DI speakers.[?][?][?]

Thank you

Pastor Cooper
 

Offline NegativEoZer0

  • Newbie
  • *
  • Posts: 4
    • View Profile
PA systems
« Reply #1 on: February 21, 2003, 02:27:26 PM »
Pastor Cooper,
       I'm sure it can be done...with the correct type of cables...sounds a bit hectic to me though...
Andrew

Offline Fourstring

  • Full Member
  • ***
  • Posts: 180
    • View Profile
    • http://groups.msn.com/TheManyFacetsofPoindexter
PA systems
« Reply #2 on: February 22, 2003, 03:37:18 PM »
Pastor,

   Let me know if I'm off base here, but it seems as though you would want to keep older R680E to power your monitors.  If that's the case, then from your RMS1662, send your main output to the PS802 and then to  your LT5 Trapazoid Speakers.  Take the monitor outs from the RMS1662 and run them to your R680E and then to you 115 DI Speakers.  Use the effects loop on the RMS1662 to loop in the Q150 & Q320 EQ's.    That should work for you.  With 2 EQ's you might even want to use one with the 1662 and one with the 680E.   That should work fine.

Derek

what do I think about when i play?  Left finger, right finger, left finger, thumb...Doh!

http://www.freetimes.com/index.php?module=FormExpress&func=display_form&form_id=11
 

GO here to vote for me as Best Bassist in the Cleveland Free Times Music Awards!!!