Username: Password:

Author Topic: M3-SW fingerboard alignment  (Read 1688 times)

Offline Andrew J. Robertson

  • Newbie
  • *
  • Posts: 1
    • View Profile
M3-SW fingerboard alignment
« on: July 23, 2006, 11:48:07 AM »
I've had the mandolin for a few years & never been happy with the action. I have adjusted the bridge as low as I could & even had to trim 1/8 off the E side but it's still too high. A luthier friend pointed out that that fingerboard is misalinged in both directions.
It's angled so that the E side is lower than the G & in the other directio it slopes down towards the bridge. Is this a common trait of this model or have I just got a dud? Otherwise it sounds great but I just get sore fingers playing it![:(]
 

Offline WEBgUy

  • Forum Admin
  • Administrator
  • Sr. Member
  • *****
  • Posts: 273
    • View Profile
    • http://www.usmusiccorp.com
M3-SW fingerboard alignment
« Reply #1 on: August 03, 2006, 04:23:08 PM »
If the fingerboard is misaligned then it is a defect. Washburns have a lifetime warranty. You should be able to get it fixed no charge. Check with your dealer. Being as you're in the UK, you may have to go through the distributor. I have the M3SW and it has great action. As a temporary problem solver, you might try lower tension strings.