Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ape

Pages: [1]
1
Bantam Basses / Re: Wiring help
« on: January 29, 2016, 03:38:24 AM »
No prob' -- always nice to find a question that I can answer. :o

The ground lead runs to the jack so that the circuit is only powered when there's a plug in the bass -- the barrel of the 1/4 plug "shorts" the lead to ground, completing the circuit. You'd only use the board "-" if you wanted to use a separate switch to turn it on/off. (I know one guy who prefers having the switch on the Volume knob; surely there's some who'd like a separate toggle, so they could leave the bass plugged in without running down the battery.)

Beter keep an eye on your brother. ;D A few years back, I got a sweeeet Ibanez EDA-905 bass for Very Cheap because someone had tried to "mod" the circuit by replacing some of the wires with 14 ga!! Sure, it took a couple hours to fix it, but he took a BIG loss on the deal.

Thank's Tony I'll get it re soldered today then, I can't thank you enough I've been really struggling, wiring isn't my forte, funny you should mention Ibanez my first bass was an Ibanez SR800 it's the only bass I've kept over these years and have not long ago upgraded it with some EMG X series pickups :-D

2
Bantam Basses / Re: Wiring help
« on: January 26, 2016, 04:58:28 PM »
There used to be some circuit diagrammes at VintageWashburn.com, but that site may have died. Fortunately, I've got an XB-400 handy.

If it's the Sound Tech WR510 circuit, the red/positive/+ lead goes to the edge of the PC board marked + DC.

The black/negative/- lead is the only wire going to the side tab of the jack.


Hi Tony, I've just checked and it's definitely the WR510 circuit and can see the +DC tab, thank you so much I can't begin to tell you how much I appreciate it, does the negative cable definitely go to the jack? the only reason I ask is on the pre amp I can see a DC- that is empty but looks like it previously had solder.

Thanks,

In advance

3
Bantam Basses / Wiring help
« on: January 24, 2016, 05:41:35 AM »
Hi all, I'm new to the site but have had a XB400 for some time and in the future want a XB925, anyway.... Here goes, I have recently got my heavily modified (body wise and fretless) XB400 back from my Brother but unfortunately it's in a bit of a state.  He in his infinite wisdom de soldered the jack and battery connector, I'm ok with soldering but not great at understanding wiring sooo. my question is (and possibly a daft question) but where do the wires need to be soldered to the jack? and where to both ends of the 9v battery connector solder to? apologies if these are dumb questions but I've looked on good old google and can find nothing, I've even tried finding close up pictures of a xb400 control cavity to give me an idea.  Thank in advance for your help :-)

Pages: [1]