Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - thebassbuilder

Pages: [1]
Bantam Basses / Re: XB 500 wiring help with blend pot.
« on: February 03, 2017, 09:55:44 PM »
Thank you so much!  I was way off where I thought the wires from the blend circuit board to the main  board.

Bantam Basses / Re: XB 500 wiring help with blend pot.
« on: February 03, 2017, 01:32:01 PM »
Last night I just wired in a volume and blend pot to a new jack.  This got it working and sounding great really.  I used the back to vertical aligned knobs for the blend and volume and left all the original electronics and jack in the cavity and just tucked them to the battery side of the electronics that it came with.  I also noticed when I was able to get the bridge pup to work with the electronics that I had to keep the bass and treble knobs all the way up and if they were not it sounded muddy and quite.  Does this sund normal for these factory electronics? It also seems as if the bass and treble are boost only.

Bantam Basses / XB 500 wiring help with blend pot.
« on: February 02, 2017, 11:43:50 AM »
I am trying to help a friend get this XB 500 running that he just bought and I had the bridge pup working but now I cannot get anything to work on it.  Attached is a pic of the blend pot and I added the pup wires back to it but I need to know if this is correct and how to hook wires up to run from the blend pot to the main circuit board.  I hope someone can help even if it is just pictures of everything.  I can then see how the wire run.  Hope someone can help as he needs this bass for church this Sunday.

Pages: [1]